The RMS-2 radar sensor (M12) with adjustable sensitivity is a motion detector. Unlike other sensors, the RMS-2 distinguishes between approaching and receding objects. This information is available to the user via two separate switching outputs. The sensitivity of the device can be configured in four stages via an internal jumper strip. The RMS-2 (M12) is connected via a standard industrial plug connector.
Special features are:
The RMS-2 radar sensor (M12) is used in the following areas in particular:
Parameters | Value | min. | type. | max. |
Operating voltage | 10 VDC | 30 VDC | ||
Power consumption | 0,5 W | |||
Temperature range | – 30 °C | 80 °C | ||
Protection class | IP 66 | |||
Housing material | PC | |||
Dimensions | 65 x 50 x 35 mm |
Parameters | Value | min. | type. | max. |
Detection range | 1 m | 6 m | ||
Beam angle, horizontal | 70 ° | |||
Beam angle, vertical | 36 ° | |||
Transmission power | 100 mW EIRP | |||
Signal output | active low/high, push pull | |||
Adjustable length Output pulse | 1 s, 5 s, 10 s, 30 s | |||
Connection | M12 male, 4-pin | |||
Direction | approximate and/or distant | |||
Antenna alignment | 0° | |||
Status LED | inside |
Standard |
ETSI EN300440-1 V1.3.1 (2001-09) |
ETSI EN300440-2 V1.1.1 (2001-09 |
VDE 0848(08/2000) Part1 |
VDE 0848(01/1991) Part2 |
ICNIRP Guidelines (04/1998) |
EN50 081-1 |
EN50 082-1 |
Pin M12 | Signal |
1 | 10 … 30 V DC |
2 | approximately |
3 | Mass |
4 | removing |
Weight | 0,0000 kg |
---|---|
Dimensions | 0,0000 × 0,0000 × 0,0000 cm |
RLS Wacon analytics GmbH
Gropiusstr. 12
31137 Hildesheim
Mon – Thu: 07:00 – 16:30
Fri: 07:00 – 13:00
© RLS Wacon analytics GmbH. Alle Rechte vorbehalten.